3/8 Jacobs drill chuck for headstock and tailstock

We supply a #0 Morse arbor for use in the tailstock for center drilling. They are available in 5/32€³, 1/4€³ and 3/8€³ sizes. Runout is .003€³ or less. If runout of less than this amount is required, collets should be used to hold the drill rather than a chuck. This larger drill chuck will hold drills from 1/32€³ (.8 mm) to 3/8€³ (9.5 mm) in diameter. Because of its longer length and ability to hold longer 3/8€³ drills, it is normally recommended for use on the longer 4400-series lathes. It comes with a #0 Morse arbor for use in the tailstock. Also included is a #1 Morse arbor and drawbolt so the chuck can be used in the lathe or mill headstock as well.