20mm (0.75 inch) Hubcentric 5x114.3 Wheel Spacers (64.1mm bore, 12x1.5 Studs) Compatible with Acura Honda ILX RL RSX TLX TSX Integra Type R TL Accord Civic Element S2000 CRZ CR-Z - Silver 2pcs

WARNING: The included lug nuts extend past the face of the spacers. IT IS REQUIRED that the back of your wheels have small cavities (at least 2" width and 1/4" deep) in the mounting pad for installation of these spacers. These cavities are NEEDED so that the lug nuts and wheel studs can sit in this pocket. Verify this before purchasing.

Thickness: 3/4" (20mm)
Bolt Pattern: 5x114.3 or 5x4.5
Centerbore: 64.1mm
Stud/Nut Thread Pitch: 12x1.5

ACURA
2001-2005 CL
2012-2019 ILX
1997-2001 Integra Type R
1991-2005 NSX (Rear Only)
2006-2019 RDX
1995-2004 RL
2002-2006 RSX
1999-2008 TL
2014-2019 TLX
2003-2014 TSX
2001-2006 MDX

HONDA
1998-2002 Accord (V6 Engine / 5-Lug Only)
2003-2019 Accord
2006-2014 Civic
2015-2019 Civic (EXCLUDES TYPE R)
1995-2019 CR-V
2010-2016 CR-Z
2003-2011 Element
2016-2017 HR-V
1995-2004 Odyssey
2003-2008 Pilot
1997-2002 Prelude
2000-2008 S2000 (Rear Only)

IMPORTANT - Must check before purchasing
- SAFETY / INSTALL WARNING: Do NOT install wheel spacer if your wheel studs or lug nuts make contact with the back of your wheels.
- Wheel Stud Length: Your vehicle's wheel studs need to be less than 3/4" (20mm). If not, the back of your wheels need pockets long/wide enough for your studs.
- Fender Gap: Measure your wheel gap for clearance. You will need at least 3/4" (20mm) of fender clearance to prevent the wheel/tire from hitting the fenderliner.
- Fitment: Use the Applications list above. If your vehicle is not on the list, message us so we can help find the correct item.

Have Questions?
Please use the "Customer Questions & Answers" feature in this listing below this section.