19mm dia x 8mm thick x M5 thread hole Rubber Coated Pot N42 Neodymium Magnet - 3.3kg Pull (Pack Of 1)

A pack of 1 - 19mm dia x 8mm thick x M5 thread hole N42 Neodymium Rubber Coated Pot Magnet. The NORTH pole is on the centre of the front face and the SOUTH is on the outer edge around it (both poles are on the same face). These Magnets are plated with 3 layers of protective coatings - Nickel + Copper + Nickel (Ni-Cu-Ni).

Each magnet can support a steel weight of up to 3.3kg vertically from the magnetic face when in flush contact with a mild steel surface of equal thickness to the magnet. Each magnet can also support up to 1.65kgs in a shear position before beginning to slide down a steel surface under the same conditions. These magnets can be fixed in place using a M5 Screw and have a maximum operating temperature of 80 degrees C.

These magnets are encased in a silicone rubber 'jacket' which increases the coefficient of friction and helps to prevent sliding. You can stick these into all steel surfaces without risk of damage or marking. Ideal to stick to your fridge to hang a key onto!

WARNING: NEODYMIUM MAGNETS ARE STRONG AND CAN BE DANGEROUS. THESE MAGNETS MUST BE KEPT OUT OF REACH OF CHILDREN AND ARE NOT TOYS. DO NOT INGEST OR INHALE AND SEEK IMMEDIATE MEDICAL ATTENTION IF ANY ARE SWALLOWED OR INHALED. THESE MAGNETS ARE BRITTLE AND WHEN BROKEN CAN BE SHARP. THESE MAGNETS SHOULD NOT BE ALLOWED NEAR MAGNETIC MEDIA AND ELECTRONIC EQUIPMENT. KEEP AWAY FROM PACEMAKERS AND INTERNAL MEDICAL DEVICES. MAGNETIC MATERIAL IS REGULATED FOR AIR TRANSPORT.